How to attach the flash cap
1. The following images show the flash cap and the flash tap without the cap. The flash cap has two notches, as indicated by the red arrows.
2. Align the notch on the flash cap with the tab on the flash tap, and then press the flash cap firmly down until it clicks into place.
How to remove the flash cap
1. You will need two tools: a Kailh switch puller and a H1.5 hex driver , outlined in red in the image below.
Purchase Kailh Switch Puller:
- Kailh Official Shop
- You can also find the product by searching the keyword "Switch Puller" on AliExpress.
2. Using a H1.5 hex driver , you can remove the two screws on the flush tap to separate the board from the case, the result is shown in the red box in the image below.
3. By inserting the Kailh switch puller into the hole at the bottom, you can hook the MX_Stem, and by pulling it out with force, you can separate the flash cap and the MX_Stem. 